Peter: 1 Version importiert

2023-10-31T08:03:08Z

1 Version importiert

← Nächstältere Version	Version vom 31. Oktober 2023, 10:03 Uhr
(kein Unterschied)

en>Peter: 1 Version importiert

2023-08-22T19:35:50Z

1 Version importiert

Neue Seite

This document describes various specifics of the '''Argos®2D D100''' camera.

= Quick start =

Here is how to start with your Argos®2D D100 Camera development board based on the CM-BF561 SoM.

*Remove the Cover from the camera. It is already unscrewed and can be removed with gentle force.

== Inside the Argos®2D D100 Camera ==
Top side connector placement:

[[Image:ECAM-BF_top_side_connector_placement.png]]

Bottom side connector placement:

[[Image:ECAM-BF_bootom_side_connector_placement.png]]

*Configure the DIP switches on the base board for parallel flash boot.
{|cellpadding="0" cellspacing="10"
||| ≥V1.0.X
|-
|||{{dipswitch|1|0|0|0}}
|-
|}

*Optionally, connect to the serial terminal to see the board's boot messages (via eCAM-EXT-Debug board on the red extension connector). If your Operating system does not install the drivers for a virtual comport, a USB-UART driver installation guide can be found [https://support.becom-group.com/wiki/USB-UART_driver_installation_guide here]
*Use your Serial Terminal Program of your choice with the following settings:
Baudrate: 115200
FlowControl: NONE
Parity: None
Stop Bits: 1
Data: 8Bit

== Starting up ==
*Connect to the Board with your serial terminal.
*Remove the cover from the lens.
*Connect 12V DC to the power connector on the back panel.
*Connect a monitor or TV via chinch cable on the back panel.
*If you like, connect Ethernet on the back panel.
*After power up a live video stream should be seen on the TV.

== Web demo application ==
*Type ifconfig into the serial terminal to get the IP adress of the Argos®2D D100.
eCM-BF561>'''ifconfig'''
Nof interfaces: 1

Int 0:
MAC address- - - - - - - - - - : AC:DE:48:01:02:03
DHCP enabled - - - - - - - - - : no
IP address - - - - - - - - - - : 192.168.0.10
Subnet mask - - - - - - - - - : 255.255.255.0
Gateway - - - - - - - - - - - : 0.0.0.0

*If you want to change the IP address, type

ifconfig -ip xxx.xxx.xxx.xxx

*To enable DHCP type

ifconfig -dhcp yes

*For further information see

: [[BLACKSheep® V1.0.0 Command Reference|Command Reference]]
*Enter the IP address of the Argos®2D D100 into your browser's address line.

[[Image:ECAM-BF_web_demo_application_start_screen.png]]

[[Category:Argos2D-D100]]
[[Category:eCM-BF561]]

Argos®2D D100 Camera Quick start - Versionsgeschichte

Peter: 1 Version importiert

en>Peter: 1 Version importiert