Quick Installation Guide (DEV-BF548DA-Lite)

Aus BECOM Systems Support
Version vom 22. August 2023, 20:35 Uhr von en>Peter (1 Version importiert)
(Unterschied) ← Nächstältere Version | Aktuelle Version (Unterschied) | Nächstjüngere Version → (Unterschied)
Zur Navigation springen Zur Suche springen

Quick Installation Guide

In order to set up and test your DEV-BF548DA-Lite board do the following steps:

1. Insert the Core Module and make sure Jumpers JP2 and JP3 are set and the Switch S3 is in Position 1 as shown in the figure below (JP1 und JP4 unset).

2. Check the correct settings of S4: 1000 1100 and S2: 0110

3. Connect the DEV-BF548DA-Lite board via USB (X11) to the PC and open a terminal program (To set up the USB-UART driver see USB-UART driver installation guide).

4. Connect the power supply to the power connector X5 off the DEV-BF548DA-Lite board.

The pre-flashed BLACKSheep starts and the LED mounted on the DEV board starts blinking.

5. Press the reset button (S1) on the DEV-BF548DA-Lite Board. After this you will see the BLACKSheep boot-screen showing up. If you disconnect from the device, you have to reconnect in your terminal program.

This shows a sample boot screen. Depending on the current software version, you might get different boot messages.

To set up the Debug Agent driver see Debug Agent installation guide

Abgerufen von „https://becomwiki.live.md-websolutions.com/index.php?title=Quick_Installation_Guide_(DEV-BF548DA-Lite)&oldid=529“